Actuator

A4988 driver Stepper Motor Driver is a breakout board microstepping driver with translator and overcurrent protection. This stepper motor driver controls one bipolar stepper motor at up to 2 A output current per coil ie, in full-, half-, quarter-, eighth-, and sixteenth-step modes, with an output dr..

L298 based Motor Driver module is a high power motor driver perfect for driving DC Motors and Stepper Motors. It uses the popular L298 motor driver IC and an onboard 5V regulator which can supply 5v to an external circuit. The module can control up to 4 DC motors without direction and speed control,..

What if you want to make a robot with a lot of moving parts or if you want to control too many LEDs with PWM outputs? PCA9685 is your solution to overcome the limited PWM outputs of a microcontroller which is a 16-Channel 12-Bit PWM/Servo Driver. This module can control 16 free-running PWM outputs w..

This 4 Channel 5V 10A Relay Module can be used across a wide range of microcontrollers such as Arduino, AVR, PIC, ARM and so on can control it. The module can control various appliances and other types of equipment with large current requirement. Relay output maximum contact is AC250V 10A or DC30V 1..

This is a 5V single channel relay without optocoupler. The relay is normally open with maximum loads: AC 250V/10A, DC 30V/10A. It has a trigger current of 5mA, and working voltage of DC 5V. The channel of the module can be triggered by a jumper to set a high level or a low level. This is a Fault-tol..

This is a Single Axis 3A Stepper Motor driver board designed for CNC router axis control with Input signal, high-speed opto-coupler isolation and a large heat sink to ensure good heat dissipation. Stepper motor driver is Semi-flow mode adjustable, semi-flow current adjustable, with a variety of semi..