VEEROBOT

This is a slotted Opto isolator module (MOC7811 or compatible), with an IR transmitter and a photodiode mounted inside. The module performs non-contact object sensing which is normally used as positional sensor switch (limit switch) or as Position Encoder sensors used to find position of the wheel. ..

PAM8403 module is a 5V Two-channel Stereo, 3W+3W, class-D audio amplifier which achieves high-quality sound reproduction. The new filterless architecture allows the device to drive the speaker directly, requiring no low-pass output filters, thus saving system cost and PCB area. With the same numbers..

What if you want to make a robot with a lot of moving parts or if you want to control too many LEDs with PWM outputs? PCA9685 is your solution to overcome the limited PWM outputs of a microcontroller which is a 16-Channel 12-Bit PWM/Servo Driver. This module can control 16 free-running PWM outputs w..

Propeller / Fan for DC Motor with four Leaf..

These prototyping boards are thin, customizable and durable. You can cut them with a penknife or scissors. Each grid is spaced 0.1"" apart. Breadboard holes are not connected so you can design your very own circuit! Specifications Double-Sided Protoboard Prototype Matrix PCB Printed Circuit Boa..

This shield is designed for Arduino Uno and similar variation boards is a prototype expansion board used to build prototype circuits. The components can either be directly soldered on the board or can connect the circuit above the mini breadboard. An adhesive double sided tape on the breadboard is u..

Have you ever felt your raspberry pi getting hot on high intensive computations, and looking for a way to make it (look and feel) cool? Hook up this 5V Mini Cooling Fan and prevent your Raspberry Pi from overheating. The fan can be directly plugged into a 5v+Gnd power pins on your raspberry pi. Rasp..

We have all been there. The tiny cable that comes along with the raspberry pi zero case is not always ideal. If you need to extend your camera a little longer, get this cable. The cable is best designed for Rapsberry Pi Zero or Zero W. Note that you only get the cable and not the raspberry pi board..

RC522 - RFID Reader / Writer 13.56MHz with Cards Kit includes a 13.56MHz RF reader cum writer module that uses an RC522 IC and two S50 RFID cards. The MF RC522 is a highly integrated transmission module for contact-less communication at 13.56 MHz. RC522 supports ISO 14443A/MIFARE mode. RC522 - RFI..